CARTON CONTENTS
See Picture 1.
1. Upper handle
2. Cable clip
3. Nut (if applicable)
4. Handle knob
5. Washer
6. Bolt
7. Lower handle
8. Fixing pin
9. Spanner/scraper tool
10. Cutting height spacers
11. Instruction manual
12. Warning label
13. Product rating label
14. Power cord (UK)
15. Switchbox
16. Start/stop lever
17. Transport wheel
EXPLANATION OF SYMBOLS ON THE PRODUCT
See Picture 2.
1. Warning
2. Read the user instructions carefully to make sure you
understand all the controls and what they do.
3. Always keep the product on the ground when
operating. Tilting or lifting the product may cause
stones to be thrown out.
4. Keep bystanders away. Do not operate whilst people,
especially children or pets, are in the area.
5. Beware of sharp blades. Beware of severing toes or
hands. Do not put hands or feet near a rotating blade.
Blades continue to rotate after the machine is switched
off.
6. Switch off! Remove plug from mains before adjusting,
cleaning or if cable is entangled or damaged.
7. Electric shock hazard
8. Keep the cable supply away from the blade.
9. This product agrees with the applicable EC directives.
10. This symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product.
For more detailed information about recycling of this
product, please contact your local council office, your
household waste disposal service or the shop where
you purchased the product.
11. Guaranteed sound power level
12. Double insulated tool
SAFETY PRECAUTIONS
IMPORTANT! READ BEFORE USE AND RETAIN FOR FUTURE REFERENCE.
a
WARNING! If not used properly this product
can be dangerous! This product can cause
serious injury to the operator. Warnings and
safety instructions must be followed to ensure
reasonable safety and efficiency in using this
product. The operator is responsible for following
the warning and safety instructions in this manual
and on the product.
General
1. This product is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning the use of the product by a
person responsible for their safety. Children should
be supervised to ensure that they do not play with the
product. Local regulations may restrict the age of the
operator.
2. Never allow children or people unfamiliar with the
instructions to use the machine.
3. Stop using the machine while people, especially
children, or pets are nearby.
4. Only use the product in the manner and for the
functions described in these instructions.
5. Never operate the product when you are tired, ill or
under the influence of alcohol, drugs or medicine.
6. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
Electrical
1. The use of a Residual Current Device (R.C.D.)
with a tripping current of not more than 30mA is
recommended. Even with a R.C.D., installed 100%
safety cannot be guaranteed and safe working practice
must be followed at all times. Check your R.C.D. every
time you use it.
2. Before use, examine the cable for signs of damage or
aging. If the cable is found to be defective, take the
product to an Authorised Service Centre and have the
cable replaced.
3. Do not use the product if the electric cables are
damaged or worn.
4. Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is damaged.
Do not touch the electric cable until the electrical
supply has been disconnected. Do not repair a cut or
damaged cable. Replace it with a new one.
5. Your extension cable must be uncoiled. Coiled cables
can overheat and reduce the efficiency of your mower.
6. Keep cable away from product. Always work away
from the power point mowing up and down, never in
circles.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before disconnecting
any plug, cable connector or extension cable.
9. Switch off, remove plug from mains and examine
electric supply cable for damage or aging before
winding cable for storage. Do not repair a damaged
cable, replace it with a new one. Use only genuine
replacement cable.
5