5
Page 2 width 2 mm less: 208 mm
v
These safety warnings apply only for lithium-ion batteries of the
POWER FOR ALL system PBA 18V.
v
Only use the battery with products of the POWER FOR ALL system
manufacturers. This is the only way in which you can protect the battery
against dangerous overload.
v
Recharge only with the charger specified by the manufacturer.
A charger that is suitable for one type of battery pack may create a risk of fire
when used with another battery pack.
v
The battery is supplied partially charged.
To ensure full battery capacity, fully charge the battery in the charger before
using your power tool for the first time.
v
Keep battery packs out of the reach of children.
v
Do not open the battery. There is a risk of short-circuiting.
v
In case of damage and improper use of the battery, vapours may be
emitted. The battery can set alight or explode.
Ensure the area is well ventilated and seek medical attention should you expe-
rience any adverse effects. The vapours may irritate the respiratory system.
v
If used incorrectly or if the battery is damaged, flammable liquid may
be ejected from the battery. Contact with this liquid should be avoid-
ed. If contact accidentally occurs, rinse off with water. If the liquid
comes into contact with your eyes, seek additional medical attention.
Liquid ejected from the battery may cause irritation or burns.
v
If the battery is damaged liquid can be ejected and cover nearby sur-
faces. Check affected parts. Clean these parts or change them if necessary.
v
Do not short-circuit the battery pack. When the battery pack is not in
use, keep it away from other metal objects, like paper clips, coins,
keys, nails, screws or other small metal objects, that can make a con-
nection from one terminal to another.
Shorting the battery terminals together may cause burns or a fire.
v
The battery contacts can be hot after use. Be careful of the hot contacts
when removing the battery.
v
The battery can be damaged by pointed objects such as nails or
screwdrivers or by force applied externally. An internal short circuit may
occur, causing the battery to burn, smoke, explode or overheat.
v
Never service damaged battery packs. Service of battery packs should
only be performed by the manufacturer or authorized service providers.
v
Protect the battery against heat, e. g. against continuous intense
sunlight, fire, dirt, water and moisture.
There is a risk of explosion and short-circuiting.
v
Only operate and store the battery at an ambient temperature
between – 20 °C and + 50 °C.
Do not leave the battery in your car in the summer, for example.
At temperatures of < 0 °C some devices may experience a loss of power.
v
Only charge the battery at an ambient temperature which is between
0 °C and + 45 °C. Charging outside of this temperature range can increase
the risk of damage to the battery and pose a fire hazard.
v
After use, allow the battery to cool down for at least 30 minutes before
charging or storing.
Electrical safety
DANGER! Cardiac arrest!
This product makes an electromagnetic field while it operates. This field
may under some conditions interfere with active or passive medical
implants. To decrease the risk of conditions that can possibly injure or
kill, we recommend persons with medical implants to speak with their
physi cian and the medical implant manufacturer before you operate the
product.
Check the area of hidden cables before trimming. Secure the working area before
using.
Only use the battery product between 0 °C and 40 °C.
Disconnect the battery in case of emergency.
Do not use the product nearby a water, or for pond care.
Protect the battery contacts from moisture.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also a risk that the poly-
bag can suffocate toddlers. Keep toddlers away when you assemble the
product.
If the trimmer vibrates heavily, replace the filament cassette and check the fila-
ment cassette holder for damage.
Use the front handle to transport the trimmer.
Use personal protective equipment.
Wear gloves for cleaning the cutting device.
Always wear eye protection.
Protective equipment such as gloves, non-skid safety shoes, or hearing protec-
tion used for appropriate conditions will reduce personal injuries.
Be careful during adjustment of the product to prevent entrapment of the fingers
between moving and fixed parts of the machine, or while assembling the protec-
tive cover.
Don’t use water, or chemical substances for cleaning the guard or other parts
of the trimmer.
Keep all nuts, bolts and screws tight to be sure the product is in a safe working
condition.
Do not disassemble the product further than the delivery status.
Warning! When wearing hearing protection, and due to the noise produced by
the product, the operator may not notice persons approaching.
While operation and transport pay special attention to the hazard for other
people.
Stay alert, watch what you are doing and use common sense when operating
a power tool.
Do not use a power tool while you are tired or under the influence of drugs,
alcohol or medication.
A moment of inattention while operating power tools may result in serious per-
sonal injury.
2. ASSEMBLY
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v
Wait for the trimmer line to stop and remove the battery
before you assemble the product.
To assemble the shaft [ Fig. A1 ]:
DANGER!
The shaft may only be assembled if the cable between the lower
shaft and the upper shaft is in a perfect condition. The shaft
may not be assembled if the cable is damaged. Contact FLYMO
customer service in such a case.
1. Carefully remove the lower shaft
(1)
together with the upper
shaft
(2)
from the packaging. In doing so, no stress may be
exerted upon the cable
(3)
.
2. Slide the lower shaft
(1)
into the upper shaft
(2)
until it audibly engages.
In doing so, the cable may not become twisted or jammed.
The shaft is correctly assembled when the gap between the upper
shaft and the lower shaft has been closed.
3. By pulling on the upper shaft
(1)
, check whether it is firmly fixed to the
lower shaft
(2)
. Once assembled, the shaft cannot be separated.
To assemble the wheel [ Fig. A2 ]:
1. Attach the wheel
(4)
to the trimmer head
(5)
. Make sure that it is located
into the groove
(6)
on the trimmer head
(5)
.
2. Clip the wheel
(4)
together on each side. Mark sure that it is secure.
3. Check that the wheel
(4)
turns freely.
To assemble the protective cover [ Fig. A3 / A4 ]:
DANGER!
The product may only be used when the protective cover is
assembled.
1. Locate the protective cover
(7)
over the trimmer head
(5)
and feed the
trimmer line through the hole in the protective cover
(7)
.
2. Push the protective cover
(7)
onto the trimmer head
(5)
.
3. Turn the trimmer head
(5)
anticlockwise until it audibly engages.
4. By turning the protective cover
(7)
, check whether it is firmly fixed to the
trimmer head
(5)
.
3. OPERATION
DANGER! Risk of injury!
Cut injury when the product starts accidentally.
v
Wait for the trimmer line to stop and remove the battery
before you adjust or transport the product.
To charge the battery [ Fig. O1 / O2 / O3 ]:
CAUTION!
v
Note the mains voltage! The voltage of the power source must
match the voltage specified on the rating plate of the charger.
42250-85.960.01.indd 5
42250-85.960.01.indd 5
12.10.21 11:37
12.10.21 11:37
