SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: [email protected]
3) Setting control mode Latched: Do not connect Jumper-1 and Jumper-2.
Press big button: Turn on the relay 1, terminal OUTPUT 1 outputs DC power.
Turn off the relay 2, terminal OUTPUT 2 no output.
Press small button: Turn on the relay 2, terminal OUTPUT 2 outputs DC power.
Turn off the relay 1, terminal OUTPUT 1 no output.
4) Setting control mode Mom Toggle: Connect Jumper-1 and Jumper-2.
Control mode Momentary (Channel 1):
Press and hold big button: Turn on the relay 1, terminal OUTPUT 1 outputs DC power.
Release big button: Turn off the relay 1, terminal OUTPUT 1 no output.
Control mode Toggle (Channel 2):
Press small button: Turn on the relay 2, terminal OUTPUT 2 outputs DC power.
Press small button again: Turn off the relay 2, terminal OUTPUT 2 no output.
We have learned remote cont
rol to the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote
controls, which are stored in the receiver.
Operation: Press and hold the button of receiver until signal LED flashes slowly; release the button, LED keeps slow flash. That means all stored
codes have been deleted successfully.
Learning the button of remote control:
1) Press the button of receiver; signal LED on the receiver keeps shining. The receiver enters into status of LEARNING.
2) Press any one button on remote control. If signal LED flashes quickly 15 times and turns off, it means learning is successful.
3) When receiver is in the status of LEARNING, press again the button of receiver, signal LED turns off, learning process will be discontinued.
4) The receiver can learn several remote controls with different codes.
Application Circuit
Power LED
Power supply
_
+
+
_
+
_
OUTPUT 1 OUTPUT 2
Lamp 1
Lamp 2
Antenna
RF module
J
um
per
-1
J
um
per
-2
IC
Signal LED
Button
Relay 1
Relay 2
LED 1
LED 2
