SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: [email protected]
3) Setting control mode Latched: Do not connect Jumper-1 and Jumper-2.
Press button 1: Turn on the relay, terminal OUT of receiver 1 outputs AC power.
Press other buttons: Turn off the relay, terminal OUT of receiver 1 no output.
…
Press button 12: Turn on the relay, terminal OUT of receiver 12 outputs AC power.
Press other buttons: Turn off the relay, terminal OUT of receiver 12 no output.
We have learned
remote control to the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote
controls, which are stored in the receiver.
Operation: Press and hold the button of receiver until signal LED flashes slowly; release the button, LED keeps slow flash. That means all stored
codes have been deleted successfully.
LEARNING the remote control:
1) Press the button of receiver; signal LED on the receiver keeps shining. The receiver enters into status of LEARNING.
2) Press any one button on remote control. If signal LED flashes quickly 15 times and turns off, it means learning is successful.
3) Press any button on the transmitter; the receiver will learn the corresponding button on the transmitter.
4) When receiver is in the status of LEARNING, press again the button of receiver, signal LED turns off, it means learning process is discontinued.
5) The receiver can learn several remote controls with different codes.
Relay
OUT
Jumper-2
Jumper-1
Power LED
Signal LED
Button
Live wire
N
L
IC
A
nt
e
nn
a
R
F
m
odu
le
Power supply
Application Circuit
Lamp
Zero wire
N
L
