SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: [email protected]
Press the small button of the transmitter: Terminals A and B stop outputting.
The manual terminals:
You can connect a manual switch to control the output of this receiver.
When connect terminals 1 and 3, Terminals A and B output DC power. And when disconnect terminals 1 and 3, Terminals A and B stop outputting.
Feedback function
:
If you want to have a feedback function (with transmitter CC-2): Turn on the third bit of the dip switch.
When the receiver gets the signal of transmitter, it will immediately send a return signal to the transmitter. When the transmitter receive the feedback
signal of the receiver, the transmitter will exude a buzzing sound like
“D~” which means it receive the feedback signal successfully.
How to pair the transmitter to the receiver:
1) Press button K1 of receiver for 1- 2 seconds; signal LED on the receiver is on. The receiver enters into status of LEARNING.
2) Press any one button on remote control. If signal LED flashes twice, it means learning is successful.
Delete all transmitters:
We have learned remote control to
the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote
controls, which are stored in the receiver.
Operation: Press and hold the button of receiver until signal LED flashes three times. That means all stored codes have been deleted successfully.