1.Antenna installation:
2. Battery installation:
Screw the antenna into the antenna hole
Unscrew the remote control battery cover using
the screw driver in the box. Use 6x AA alkaline
batteries in the remote control.
1. Only adults should change or install the batteries.
2. Non rechargable batteries should not be recharged.
3. Remove the batteries if they run out.
4. Make sure the batteries are installed in the correct polarity
into the remote control.
5.Do not mix different battery types.
6. Do not mix old and new batteries.
7. Disguard the batteries in a WEE bin only.
8. Do not short circuit the batteries.
2. Transmitter Installation
Charging by using the remote control:
Turn the aeroplane “OFF”, open the front charger cable cover on the front of the remote
control. Then plug the charger cable in to the plug socket on the underneath of the aero-
plane. Then switch the remote control “ON” (see picture below).
- Make sure the aeroplane is off before connecting the charging cable.
-Charging takes 20-25 minutes and it will fly for 5-6 minutes.
-Whilst charging the light on the remote control will be “ON” and green. When the
aeroplane is fully charged the light will turn “OFF”.
-If the indicator light flashes on the remote control, change the
batteries in the remote control.
-In cold weather the battery life will be reduced.
Do not charge the aeroplane
for around 5-6 minutes after
flying. This stops the battery in
the controller and aeroplane
from over heating.
Charging should be done by an
adult. Do not leave unatttended
whilst charging
Summary of Contents for Flight 2 Channel Series
Page 1: ......
