2
Specs of the CC
Weight of PCB: 11g (without wires)
Size 35x42mm (with cut off corners)
Mounting holes 30x30mm, 3.2mm diameter
4x KISS ESC 32bit ESC's 2-4S 16A (21A active current limiter)
KISS FC F3 32bit with serial, buzzer and LED ports
5V output supports max. 1A
The CC supports full telemetry and logging via serial port. Setup is the same as with the regular KISS FC.
Flashing & Setup
For flashing the FC and ESCs you will need one of the
Flashing the FC on Windows PCs also requires the
software. Install it before you plug in the CC in
bootloader mode for the first time! Please follow the instructions for
Press and hold the boot button.
Plug in the CC into your USB
Windows will now recognize the CC and install the bootloader driver
Start Defuse and follow the steps for
Flashing the ESCs through the GUI
Warning! Always remove props before flashing the ESCs as you will have to connect a Lipo to power them during the
flashing.
Connect the lipo to the CC and let it boot up properly.
Connect the USB to your PC. No matter what OS (Win, Mac…) you use, you can flash all ESCs at once through the
GUI (min. v1.14)
Once connected via serial COM port go to the “ESC Flasher” tab of the GUI and follow the steps.
Disconnect the CC, re-power and re-connect it. Go to the Flasher tab again and look if the serial numbers and
the firmware version are displayed. This is important to check if the flashing went ok. If one of the ESCs is
mismatching you wouldn’t be able to use the CC correctly.
Summary of Contents for KISS Series
Page 3: ...3 Connections Wiring...
Page 4: ...4...
