5.Battery charging notes
5
.
01Transmitter charger:
A. Install the battery to transmitter with correct direction, and cover it.
B. Connect the charger to the main connector.
C. Connect the charger to the transmitter
Connector.
D. Cut off the power supply immediately after
Recharge completed.
A. Connect the charger to the main connector.
B. Connect the Rechargeable receiver with battery charger
C. Recharge completed, cut off the power supply immediately.
MODELS
:
FS
-
GT3
4
Digital
propotional
radio
control
sytem
Http
:/ /
www
.
flysky
-
cn
.
com
If your transmitter, receiver using a nickel-cadmium, nickel-metal hydride rechargeable battery,
you have to well-check before you fly. If lack of electricity, it could happen those phenomenon
like inadequate control or out of control, resulting accident. So please charge immediately when
如果您的发射机.接收机使用的是镍镉.镍氢等可充电电池,在飞行前请您务必检查电池电量.如果电量不
足,可能导致控制距离不够或者失控的现象,从而产生意外.所以电池电量不足时请及时充电.
If you are using a nickel-cadmium, nickel-metal hydride batteries for recharging, please use our
company dedicated charger. If the electrical current is too large and it may lead to temperature
over-heated and cause fire burning accident. Please cut off the power supply immediately after
recharging. Please take out the battery from the transmitter when you are not using it within a
period, it is because the battery may damage the aircraft batteries, thus being exposed.
如果您使用的是镍镉.镍氢电池进行充电,请您使用我们公司的专用充电器.因为如果充电电流太大可能
导致电池温度太高,从而燃烧起火带来意外。充电完成请您即时切断电源。当您长时间不使用时请您
电池从发射机中取出，因为电池可能导致发射机电池片损坏，从而接触不良。
5
.
02Receiver charger:
1.将可充电电池按方向装入发射机，并合上电池盖；
2.将充电器插入市电接口；
3.将充电器充电接头插入发射机充电接口；
4.充电完成后，即时将电源切断。
1.将充电器插入市电接口；
2.将可充电接收机用电池接口与充电器充电接口连接；
3.充电完成后,即时将电源切断.
