Flite 3S 18350 Powered Induction Heater
Quick Start Guide
Flite Quick Start Guide
©Fluxer Heaters LLC, 2020
V1.0
https://www.fluxerheaters.com
Thank you for purchasing a Flite™ induction heater! Flite packs a lot of functionality into its
small size. This is an overview of the most important info.
18350 Battery Requirements:
•
3x matching 18350 batteries
•
Flat top
•
Unprotected/high discharge (CDR >= 9A)
•
1100+ mAh capacity recommended. 900 mAh is serviceable, less than 900 mAh capacity
not recommended
Flite has an on-board battery management system that includes balanced charging, low voltage
cut off, reverse polarity protection, and over voltage protection.
Battery Charging in Unit:
To charge the Flite’s batteries in place, attach a 12.6VDC charging adapter (2.1mm x 5.5mm
center positive tip) to the Flite’s DC port.
Suggested charge rate: 12.6VDC@1A. Charge status is managed by the charging adapter.
To use the Flite:
1.
Slide Flite’s power switch to Pulse or Full, as desired. Pulse/PWM operation is explained
below.
2.
Insert the Dynavap into the coil and either press the cap to the two contacts to activate
the heater, or press the push button on the side if present. If pressing the cap against
the switch contacts,
press lightly to moderately; do not grind or use excessive force!
3.
Remove when the Dynavap clicks, or to taste.
Cap-as-Switch™ suggestions for best results:
•
Press lightly to moderately to activate;
do not grind the cap against the contacts or use
excessive force!
•
If you’re having trouble making a good connection, rotate the cap a few degrees and try
again. When you do make a good connection, note the position of the digger so you can
return the cap to this spot in the future.
•
Clean caps connect better. Use isopropyl alcohol to clean the end of your cap.
NOTE
: The cap-as-switch feature is new to the Flite. If you decide you don’t like it, Fluxer
Heaters will be glad to convert your cap-as-switch heater to a push button heater for the
cost of postage. Email
for more info.
