- 6 -
6.3 Setting the calibrating factor
After pressing the "Mode" key, the calibrating factor set appears in the display. Pressing the
"Total" key results in the calibrating factor being counted up in 0.010 steps and pressing the
„Reset“ key in it being counted down accordingly.
Press the "Mode" key and the set calibrating factor is taken on.
6.4 Resetting all settings (initialisation)
The effect of pressing and holding the "Total" and "Reset" keys at the same time when setting
the measurement unit or calibrating factor is to delete all the meter values and carry out an
initialisation.
Following values are initialised:
Measurement unit:
Litre
Calibrating factor:
1.000
Delivery quantity:
0.00 litres
Totaliser:
0 litres
6.5 Ending the programming mode
In order to end the programming mode, the "Mode" key is again to be pressed after setting the
calibrating factor. The meter then reverts to the basic state. When no key is pressed for over
5 minutes in the programming mode, the meter automatically returns to the basic state.
