INSTALLATION AND USAGE:
Please verify that all components of the light fixture are undamaged before putting it into operation.
Before any kind of maintenance, always disconnect electrical supply of the light fixture.
• Make sure the light fixture is mounted correctly and securely positioned on the aquarium
before operating the appliance.
• On a plain glass aquarium always ensure that the brackets are on the outside of the aquarium
frame. If needed, the extendable mounting brackets can be adjusted accordingly to ensure
proper fit on aquarium.
• Connect the plug from the transformer to the plug on the fixture.
• Connect the transformer to electrical supply.
MOUNTING BRACKET INSTRUCTIONS
This is a mounting system only and does not provide power to the LED strip.
REMOVING THE EXISTING LIGHT TUBE
• Disconnect the T8/T5 lighting system from the power supply and do not reconnect.
• Please ensure that the LED strips are not connected to the power supply when
mounting into the T8/T5 lighting system using the mounting brackets.
• Unscrew both end caps and move them into the center of the tube.
• Remove the tube by sliding it gently out of the fitting.
INSTALLING THE MOUNTING BRACKETS
• Clip the mounting brackets over the ends of the
extending arms of the LED strip, as per the photo
(A). You may need to pull out the
extending arms slightly to do this.
• For T5 lighting systems: fit the
end caps over the end of the mounting
brackets, to face inwards.
• For T8 lighting systems: click to fit the T8
ring adapter onto the end of each
mounting bracket, then follow the instructions
above for T5 lighting systems.
• Fully tighten the end caps back onto the threads,
being careful not to cross thread or over tighten.
You may need to extend or retract the extending
arms to make the LED strip fit perfectly (B).
• WARNING: Before connecting the power supply,
ensure that the LED strip is securely fastened to
lighting system of the aquarium so that it is
stable and cannot fall into the water. The
LEDs are tested to IPX7, which means they
can withstand temporary
submersion. NOTE: THIS IS NOT A SUBMERSIBLE LIGHT
• Connect the power supply to the LED strip and switch on.
INSTALLING THE CEILING BRACKET
• Clip the ceiling brackets over the back (side with
fins) of the LED strip.
• Use suitable fixings for the intended mounting
surface. If you wish to bond the brackets to glass
or plastic use aquarium silicone.
• WARNING: Do not screw the bracket onto any
housing containing electrical wiring or
connections, such as lighting ballasts,
due to severe risk of electric shock.
A
B
SCAN HERE to learn more
and download the free Fluval Smart app
or search ‘Fluvalsmart’ in app store.
For full instruction manual and video on set up of Bluetooth® application, visit:
fluvalaquatics.com/aquaskybluetooth
FULLY
CONTROLLABLE
FROM YOUR
SMART PHONE
OR
TABLET
