Fluke Victoreen 190, Operator'S Manual

Page: 14 / 38

Victoreen 190
Operators Manual
3-2
2. Remove the battery compartment cover to gain access to the batteries.
3. Replace the batteries one at a time, observing proper polarity (refer to Figure 3-1)
The unit may make beeping sounds while inserting
the batteries.
4. Replace the battery compartment cover, securing it with the two-quarter turn fasteners.
Figure 3-1. Battery Installation (For 190AC and 190F only three 9-volt batteries are
installed.)
3.4 Probe Holder Installation
Extreme caution should be used when connecting
the probe to the meter. Improper connection may
result in injury, damage to the instrument, or
damage to the probe.
1. Attach the included Velcro strap through the strap slot in the mounting bracket.
Two Velcro straps are included. Use the strap that
fits the type of probe being utilized.
2. Attach the blade type-mounting bracket to the Model 190 Survey Meter, by performing the
following:
a. Remove and discard screw (B) from the Model 190.
b. Place the bracket in the correct position on the Model 190.
NOTE
WARNING
NOTE