3-7
Replacing the Line Cord
To install a new line cord:
1
Carefully slide the modular connector of a new line cord through the hole in the end of the
test set. Do not damage the connector pins or plastic tab.
2
Lay the line cord inside the groove in the bottom of the test set housing (see Figure 3-4,
right).
3
Connect the RJ-45 modular connector of the line cord in the housing on the test set (see
Figure 3-4, left).
4
Insert the plastic clip over the line cord strain relief at the base of the test set housing (see
Figure 3-3, right) and snap tightly into place.
5
Replace the batteries on each side of the line cord strain relief.
6
Place the battery door back on the test set and fasten the four screws.
bdx08.eps
Figure 3-4. Line Cord Connector and Cord Placement
Summary of Contents for TS 1200
