Setting the Temperature Span (Manual)
When put into manual ranging, the span setting adjusts the palette over a
temperature range within the total range of the Imager. See Figure 1. To
adjust the temperature span:
1.
After entering the manual range mode (See the “Setting the
Range” section above), press the softkey labeled
Span
.
2.
Press the softkey labeled
Increase
to widen the temperature span
or
Decrease
to narrow it.
3.
Press the softkey labeled
Done
to set the Imager’s range level.
Switching Between PIP and Full IR
The Imager can be set to display a full infrared image (Full IR) or an infrared
image surrounded by a visual light image (Picture-in-Picture / PIP). To
switch the r TiR Imagers between a full infrared display and Picture-In-
Picture (PIP) display:
1.
Press
F2
until IR
Fusion
appears over F3
d
.
2.
Press the softkey labeled
Up
or
Down
to toggle the display between
PIP
and
Full IR
.
3.
Press the softkey labeled
Back/Done
when finished.
Reviewing and Deleting Stored Images
To view stored images on the SD card:
1.
Press
a
until
Memory
appears over
c
.
2.
Press the softkey labeled
Memory
to reveal the review menu.
3.
Press the softkey labeled
Review
.
4.
Press the softkey labeled
Up
to display the previous image or
Down
to
display the next stored image.
To delete a single Image from the SD card:
1.
Perform the steps under viewing stored images above to bring the desired
image to the display.
2.
Press the softkey labeled
Select
.
3.
Press the softkey labeled
Delete
.
