Fluke OF-500-01 OptiFiber, Technical Reference Handbook, Page: 191 / 278

Using the Loss/Length Option
Finding Connections with FindFiber
7-39
7
Finding Connections with FindFiber
The FindFiber function is available with the loss/length test
option. This function helps you trace connections at patch
panels and quickly check fiber continuity.
Note
The FindFiber function is not available in Far End
Source mode.
Using FindFiber in Smart Remote Mode
Use FindFiber in Smart Remote mode to help you determine
which fibers go to which connectors at a patch panel.
Figure 7-14 shows the equipment needed for using
FindFiber in Smart Remote mode.
Figure 7-14. Equipment for Using FindFiber in Smart Remote Mode
ajt50f.eps
A
Tester with OFTM-5612B or OFTM-5732 module and
smart remote (DTX remote shown). Match connector
adapters to the connectors in the link.
B
Spare battery pack (optional)
C
Two ac adapters with line cords (optional)
D
Two duplex reference test cords. Match the fiber to be
tested. One connector on each cord must be SC. For the
others match the connectors in the link.
E
Fiber cleaning supplies