Fluke NORMA 6003, User Manual, Page: 59 / 98

Power Analyzer
Operation
53
Trigger Setup:
1. From the main screen of Scope select
C
( Trigger ).
2. Push
A
( Source ) until the block with the same color as the waveform of the trigger signal is
shown.
3. Push
B
( Method ).
4. Use the up and down arrow (
M N
) keys to move the cursor to the Type drop down box and
push
]
( Select ) on the control panel.
5. Use the up and down arrow (
M N
) keys to select the appropriate option and push
]
( Select ).
6. Use the up and down arrow (
M N
) keys to move the cursor to the Slope drop down box and
push
]
( Select ) on the control panel.
7. Use the up and down arrow (
M N
) keys to select the appropriate option and push
]
( Select ).
8. Push
Q
( Back ).
9. Use
D
( Level ▲ ) and
E
( Level ▼ ) to adjust the trigger level as needed.
Measure with The Cursor
Use the cursor to measure the waveform digitally.
Enter the Cursor Setup Menu:
•
From the main screen of Scope select
D
( Cursor ).
The options are as shown in
Table 22
.
Table 22. Cursor Setup
Item Description
Select
A
Select the measured signal
Push
A
( Select ) to cycle through the current measured signal.
The currently selected signal is shown under the “ Select ” label with a color
block of the same color as the signal waveform.
The selectable signals are the selected signal in the “
Select ” menu, which is
the signal shown on the “ Vertical Axis Scale ” of the screen, see
Select the
Waveform to Display
.
Type
B
Measurement type
P ush
B
to cycle through and select the cursor measurement types. Cursor
Measurement types include single vertical line, double vertical lines and double
horizontal lines.
- (single vertical line)
- (double vertical lines)
- (double horizontal lines)