Fluke NORMA 6003, User Manual, Page: 56 / 98

NORMA 6003/NORMA 6003+/
NORMA 6004/NORMA 6004+
User Manual
50
Table 20. Scope Screen
Item Description
a
Status Bar
See
Status Bar
for details.
b
Difference between cursors / average at cursor
- The difference between the 2 cursors is displayed when the double horizontal
cursors are activated.
- The average value of the cursor position is displayed when the single vertical line
cursor is activated.
- The difference between the 2 cross points of the 2 cursors and waveform is
displayed when the double vertical cursors are activated.
- If the cursor is off, no values are displayed in this area.
See
Measure with The Cursor
for details.
c
Value at cursor /time difference
- The values of the 2 cursors show separately when the double horizontal cursors
are activated. HIGH: Value of the upper cursor; LOW: Value of the lower cursor.
- The maximum and minimum values of the cursors show when the single vertical
cursor is activated. MAX: Maximum value; MIN: Minimum value.
- The time difference (t) between 2 cursors and the frequency value (1/t) calculated
accordingly are shown when the double vertical cursors are activated.
- If the cursor is off, no values are shown in this area.
d
Trigger Status
Displays the current trigger status. See
Trigger Setup
for details.
e
Vertical Axis Scale
Displays the vertical axis scale of each waveform on the current screen, which is the
value represented by each grid.
The left side is the parameter symbol, and the right side is the vertical axis scale of the
parameter. The specific unit depends on the corresponding waveform.
The color of the scale depends on the color of the corresponding waveform.
f
Cursor
Cursor mode includes single vertical line, double vertical lines and double horizontal
lines. See Measure with The Cursor for details.
g
Waveform
Up to 4 user-selectable waveforms can be shown simultaneously on the screen. See
Select the Waveform to Display
for details.
h
Trigger Identifier
Indicates the trigger position and level. The shape of the trigger identifier depends on
the current trigger mode. See
Trigger Setup
for details.
i
Ground Level
Represents the ground potential