11
How to Clean Connectors
2
To clean a bulkhead connector, remove the device’s cap. To
clean the connector on a fiber cable, remove only the tip of
the cap.
3
If necessary for a bulkhead connector, extend the tip of the
device.
4
Push the device straight into the connector until you hear a
loud click. See Figure 6. Then remove the device.
5
Use a video microscope to inspect the connector. If
necessary, clean and inspect the connector again.
If the mechanical device does not clean the connector
sufficiently, use a swab and solvent to clean the connector.
ghm09.eps
Figure 6. How to Use a Mechanical Device
to Clean Connectors
How to Use Swabs, Wipers, and Solvent
To clean bulkhead connectors:
1
Use a video microscope to inspect the connector. If it is dirty,
continue to step 2.
2
Touch the tip of an optical-grade solvent pen or swab
soaked in solvent to a dry, optical-grade wiper.
3
Touch a new, dry swab to the solvent on the wiper.
-continued-
CLICK!
CLICK!