190M Series III
Users Manual
10
Figure 5. The Screen After an Auto Set
Use
L
K
N V
at the bottom of the keypad to change the view of the waveform
manually.
Automatic Scope Measurements
The test tool offers a wide range of automatic scope measurements. In addition to the waveforms
you can show four numeric readings: READING 1 - 4. These readings are selectable
independently, and the measurements can be done on the input A, input B, input C or input D
waveform.
To choose a Peak-Peak measurement for Input A, do the following:
1. Press
P
to show the SCOPE key labels.
2. Open the
READING
menu with
2
.
3. Select the reading number with
1
, for example
READING 1
.
4. Use the cursor and
E
to select
on A
. Observe that the highlight jumps to the present
measurement.
5. Use the cursor and
E
to select the
Hz
measurement.
Observe that the top left of the screen shows the Hz measurement. See
To choose also a frequency measurement for Input B as second reading:
1. Press
P
to show the SCOPE key labels.
2. Open the
READING..
menu with
2
.
3. Select the reading number with
1
, for example
READING 2
.
4. Use the cursor and
E
to select
on B
. The highlight jumps to the measurements field.
5. Use the cursor and
E
to open the PEAK menu.
6. Use the cursor and
E
to select the Peak-Peak measurement.
