Page 7
FW-F013-A-M_v0404_01_EN.docx
2 OPERATIONAL
2.1
GENERAL INFORMATION
This chapter describes the daily use of the F013-A. This instruction is meant for users / operators.
•
The F013-A may only be operated by personnel who are authorized and trained by the
operator of the facility. All instructions in this manual are to be observed
•
Take careful notice of the "Safety rules, instructions and precautionary measures" in the
front of this manual.
2.2
CONTROL PANEL
The control panel has three keys. The following keys are available:
Fig. 2: Control panel.
Functions of the keys
PROG
-key
This key is used to program and save new values or settings.
The PROG-key is also used to gain access to SETUP-level; please read chapter 3.
SELECT
-key
This key is used to SELECT the displayed information, like accumulated total and flow
rate.
CLEAR
-key
This key is used to CLEAR the value of total.
2.3
OPERATOR INFORMATION AND FUNCTIONS
In general, the F013-A will always function at Operator level. The information displayed is dependent
upon the SETUP-settings. The signal from the connected sensor is processed by the F013-A in the
background, whichever screen refresh rate setting is chosen. After pressing a key, the display will be
updated very quickly during a 30 second period, after which it will slow-down again.
Fig. 3: Example of display information during process.
For the Operator, the following functions are available:
•
Display flow rate / total or flow rate
This is the main display information of the F013-A. After selecting any other information, it will
always return to this main display automatically.
Total is displayed on the upper-line of the display and flow rate on the bottom line.
It is possible to display flow rate only with the large 17mm digits; in this instance press the
SELECT-key to read the total.
When "-------" is shown, then the flow rate value is too high to be displayed. The arrows
indicate the increase/decrease of the flow rate trend.
R
U
N
