Remember that all Fluidmesh devices within a network
must
use the
same Prodigy version.
IMPORTANT
Prodigy 2.0 is
not
compatible with Prodigy 1.0. Do not
implement the two protocol versions within the same network.
If you are expanding an existing network using new Fluidmesh
hardware components, make sure that all components are
compatible with each other by:
1. Upgrading all network components within the same
network to firmware version 6.5 or higher.
2. Configuring all network components within the same
network to operate using either Prodigy 1.0 or Prodigy
2.0.
Option 2 is recommended if the network does not contain older
Fluidmesh devices that are not compatible with Prodigy 2.0.
If needed, change the unit's Prodigy version by clicking the
Prodigy 1.0
radio button or
Prodigy 2.0
radio button.
Save the Prodigy version settings by clicking the
Save
button.
Alternatively, clear the settings by clicking the
Reset
button.
Changing the LAN parameters
The LAN Parameters box (below) contains the entry controls for local-
address setting.
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC
Page 68 of 180
