Figure 55. Multicast dialog (Bridge mode)
• The unit ID number of the local unit is shown as the
LOCAL BRIDGE ID
(
).
• The unit ID number of the Bridge unit to which the local unit
is linked is shown to the right of '
ASSOCIATED WITH
REMOTE BRIDGE ID
'.
Figure 56. Configurator interface (Unit ID information)
3.
Choose the Enabled or Disabled option from the
Multicast
Forwarding:
drop-down menu.
4.
Save the multicast settings by clicking the
Save
button.
Alternatively, clear the settings by clicking the
Reset
button.
6.6.6. SNMP configuration
The SNMP window can be used to configure an SNMP v2c or SNMP v3
service to run on the Fluidmesh 4200 FIBER.
Both walk-throughs (no agent-to-manager notifications) and traps (agent-
to-manager notifications enabled) are supported. If SNMP traps are
enabled, you can specify the server address to which monitoring
information must be sent.
IMPORTANT
The same SNMP configuration must be set for all Fluidmesh
units in the wireless network.
For detailed information on Fluidmesh unit SNMP
configuration, refer to the
Fluidmesh SNMP FM-MIB OID Table
and MIB configuration files. These can be downloaded from
the Fluidmesh Partner Portal (
Documentation
section >
User
Manuals
>
Advanced Manuals
.)
To change the SNMP settings, do the following steps:
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC
Page 110 of 180
