12
13
STEP 6:
FINISHING STEPS
STEP 5:
SECURE TANK TO BOWL
A: INSTALL RUBBER WASHERS
Place one rubber washer on each
tank bolt.
B: INSERT BOLTS INTO TANK
Place tank bolts through bottom
holes of tank.
C: SECURE TANK ONTO BOWL
Set bowl onto tank. Slide one
metal washer onto each bolt, then
loosely tighten
hex nuts. Alternately
hand-tighten hex nuts onto each one
of the bolts evenly, then use pliers
to tighten hex nuts until tank is snug
and it does not rock.
Do not over-
tighten.
Rubber
washer
Large Adjustable
Pliers
C: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
Twist to the
right (counterclockwise)
*Hand-tighten only. Do not overtighten.
RIGHT
D: TURN ON WATER
Check for leaks.
TURN
COUNTER-
CLOCKWISE
E: WATER LEVEL
After the tank stops filling,
water level should fill the
tank to
roughly ½” below
top of overflow pipe to
ensure a proper flush.
1/2"
Overflow Pipe
Top of Overflow Tube
Water Level
*
Overtightening may damage fill valve or coupling nut, potentially causing flooding.
Make sure the float cup does not touch the tank walls or tank lever and flush valve.
**
The top of the overflow pipe
must be
a minimum of 1"
below
tank lever hole.
B:
CONNECT FLAPPER CHAIN
Attach clip to the tank lever directly
above the flapper. Leave roughly ½”
of slack (small ‘J’ shape) in the chain.
A:
ATTACH REFILL CLIP TO
OVERFLOW PIPE
Note: If refill tube is too long to fit
inside tank with lid closed, remove
refill tube from fill valve refill port, cut
tube and reattach to port.
Scissors
(Optional)
Rubber washer
(Omit for
Kohler
®
Toilets)
Tank
Metal washer
Large hex nut
Bowl
