MONSOON 2.5
OPERATION GUIDE
FZVABN-2.5
© WESSOL, LLC 2021
- 8 -
GETTING STARTED
Setting up your sprayer
1. Remove the nuts and bolts,
holsters, nozzles, and pins from
the tank strainer (3). Set aside.
2.
Insert the trolley handle (17) to
desired height into the tank (2).
Tighten the two black knobs until
the handle is secured. Place the
hose brackets (11) at the back of
the tank and attach with screws.
3. Place the top wand holster (4)
at the protruding holster mount
on the tank. While holding the
top holster, place a nut (6) on
the side with the hexagonal slot
and screw the bolt through the
other side until it fastens into
the nut. Repeat for the other
slot and the bottom holster (5).
4. Place the trolley wheels (16) on
either side of the sprayer. Slide
a pin through each side of the
center axle and widen to keep
the wheels in place. You may
have to bend the pin to secure it.
5.
Take the spray gun (10) and attach
it to the threaded fitting on the
end of the hose (12). Tighten
the fitting to ensure the gasket
properly seals the connection.
6. If spraying with the stainless-
steel spray wand (9), pull back on
the collar of the quick-connect
fitting on the spray gun. Insert
the male wand quick-connect
into the female spray gun fitting
and push the collar back into its
original position. Nozzles can be
attached with the same process.
7. Snap the spray wand into the wand
holster and place any unused
nozzles into storage slots until
ready to spray.
2
3
4
5
