84636-Instruction-English—200806 2 of 5 Printed in China
and rear of heater to adjacent walls. Ensure combustible materials (i.e.
furniture, pillows, bedding, papers, clothes, curtains etc.) have a
minimum clearance of 3 feet (0.9m) from front of heater. Also keep
these items from the sides and rear of the heater.
6. Extreme caution is necessary when and heater is used by or near
children or invalids and whenever the heater is left operating and
unattended.
7. Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock, fire, or damage
the heater.
8. To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use soft surfaces, like a bed, where openings may
become blocked. Clean as often as necessary to prevent dust from
clogging the grilles or element fins. Keep all electrical cords, drapes,
paper, plastics and other combustibles away from heater.
9. To disconnect heater, turn selector knob to off position, then remove
plug from outlet.
10. Do not run under carpeting. Do not cover cord with throw rugs, runners,
etc. To prevent entanglement or damage, route cord away from high
traffic areas.
11. A heater has hot and arcing or speaking parts inside. Do not use it in
areas where gasoline, paint, or flammable liquids are used or stored.
12. If this heater or its power cord become damaged or malfunction in any
way, unplug heater, discontinue use, and have unit repaired by a
reputable repair service.
13. Do not operate heater without stand.
14. Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or
injury to persons.
15. Avoid the use of an extension cord because the extension cord may
overheat and cause a risk of fire. If you have to use an extension cord,
the cord shall be No. 10 AWG minimum size and rated minimum
6000W.
16. Always unplug heater when not in use.
17. Mounts on wall or ceiling with enclosed bracket in garage or workshop.
May also be placed on hard floor, table top or shelf.
18. If heater is to be tilted on horizontal axis after mounting
– ensure a
minimum clearance of 26.5 inches (67cm) between floor and bottom of
heater. Also, when mounted to ceiling, ensure a minimum clearance of
3.5 inches (9cm) from ceiling to top of heater. Ensure the air discharge
is parallel to or away from walls.
ASSEMBLY
This Heater has been pre-assembly in factory.
