7)
Place the supplied hanger clamp assembly
#444HA
onto the outlet of
the muffler and into the factory rubber mounts on the vehicle. Tighten just
enough to hold in position.
8)
Place tailpipe assembly
#16757S
up over the rear axle and into the
muffler outlet. Connect the hanger at the rear of the pipe to the rubber mount
on the vehicle. Adjust the tip to the desired rotation and tighten the clamp
enough to hold, but still allow for adjustment.
9)
Adjust the position of all pipes and mufflers to provide a satisfactory fit. This is a tight fitting
system, so take your time and be patient, tightening and adjusting a little bit at a time. Be sure to
maintain an adequate clearance around all parts of the system to avoid rattles or damage to heat
sensitive components. Once you’re happy with the fit, tighten all connections down securely. For a
cleaner appearance and more secure installation, we highly recommend welding all slip-fit
connections.
PACKING LIST
Qty.
Description
Part #
1
Muffler
852572-Z
1
V6 Inlet Pipe
16756S
1
V8 Inlet Pipe
16759S
1
Tailpipe
16757S
1
Parts Kit
PK625
1
Rear Muffler Hanger
444HA
1
2-1/2" Band Clamp
MC250BS
2
M10x1.25x65MM Bolt
HW231
2
½” x 1½” Steel Spacer Tube
HW506
2
3/8” Flat Washer
HW303
Pg. 2 of 3
Technical Support (800) 544-4761
