|
6
MN301340 Rev A2
Installation
Step Four
CONNECTION TO A SWITCH CAR KIT (LM30 SERIES)
In order to attach the LV10 series to a Smart Trak (LM10 series) fitting, a Switch Car Kit (LM30 series) is
required. The LV10 series can be attached in two ways, without the bayonet adapter and with the bayonet
adapter.
Without Bayonet Adapter
With Bayonet Adapter
The use of the bayonet adapter will increase the overall length of the LV10/LM30 series assembly. This will
result in a lower activation point within the tank due to the added length. It is recommended to remove the
bayonet adapter when interfacing with Smart Trak.
First, remove the bayonet
adapter by pressing down
twisting the adapter.
Next, thread the sensor wire through the O-ring and the
sensor car and out through the hole between the sensor
car shoe and the locking bolt. Set the O-ring into the
LV10. Push the sensor into the bayonet side of sensor
car. Screw the bayonet adapter onto the sensor until the
sensor seats against the pit inside the adapter.
