|
2
QS310140 Rev A2
WELCOME TO THE ECHOPOD
®
QUICK START
The EchoPod
®
Quick Start provides basic mounting, setup and use instructions for getting the EchoPod
®
up and running quickly. If you have a non-standard installation or setup requirement that is not
addressed here, please refer to the EchoPod
®
Manual or other support documentation located at
flowline.com.
WE DO YOUR LEVEL BEST
Thank you for purchasing EchoPod
®
. The sensor provides integrated LCD and three push-button
configuration. This quick start includes everything you’ll need to get the sensor up and running.
COMPONENTS
Depending on how the sensor part number that was shipped, EchoPod
®
comes with a Viton
®
gasket for
installation and the Quick Start.
EchoPod
®
UG06-0001-00
UG06-0001-01
UG06-0011-00
UG06-0011-01
EchoPod
®
UG12-0001-00
UG12-0001-01
UG12-0011-00
UG12-0011-01
USB
®
Key Fob
P/N: LI99-2001
Viton
®
gasket (2”)
P/N: 200129
G threaded version only
Viton
®
gasket (3”)
P/N: 210157
G threaded version only
ENCLOSURE
While the switch housing is liquid-resistant the EchoPod
®
is not designed to be operational when immersed. It
should be mounted in such a way that the enclosure and transducer do not come into contact with the
application media under normal operational conditions. Before closing the enclosure, make sure that the
enclosure gasket is properly seated, and that any conduit fittings, cable connectors or plugs are installed
correctly and sealed.
Note:
If using the Flowline LM90-1001 (liquid tight fitting) on the ½” conduit, the cable
minimum is 0.170” (4.3mm) and the maximum is 0.450” (11.4mm).
CONFIGURATION
When configuring EchoPod
®
, choose either the WebCal
®
or Push Button method. Either method will
accomplish the goal of sensor configuration. Changes to the configuration can be made using the alternative
method. When beginning with one method, it is recommended to complete the configuration before using the
other method to make any adjustments.
Note: When connecting the sensor to the WebCal
®
Software, you must remove the display or the software will
not connect. Once completed, you can re-connect the display to the terminal.
