DIFFERENT PRESSURE CONTROL VALVE
FlowCon DPCV
FlowCon International assumes no responsibility
for mistakes, if any, in any printed material.
Denmark
Dubai
USA
Singapore
www.flowcon.com
1H95000 - 04/2016
- 4 -
Page 1: ...lon tape is recommended WHEN USING HEMP AS PIPE SEALANT ENSURE NO STRANDS ARE LEFT IN THE VALVE OR PIPING The capillary tube is available with straight male end connections with gaskets for sealing One end is mounted on the upper part of the DPCV instead of the black plastic plug The other end is mounted at the inlet of the riser fx in a FlowCon ABS For each end of the capillary tube start by moun...
Page 2: ...change the setting please remove the black lock ring and turn the black top part by hand as shown in figure 4 do not use more than 1 Nm force Turn the black top part clockwise to increase and counter clockwise to decrease the setting The setting can be seen directly on the valve because the scale is printed on the top part which is turned and the setting is defined by the groove in the brass part ...
Page 3: ... to function as a differen tial pressure control valve again the setting is kept Be sure not to use more than 1Nm torque General Water must always be suitably treated clean and free from debris It is recommended that a strainer be installed prior to the inlet of the capil lary tube to prevent damage or blockage due to debris Further it is recommended not to exceed the maximum operational different...
Page 4: ...DIFFERENT PRESSURE CONTROL VALVE FlowCon DPCV FlowCon International assumes no responsibility for mistakes if any in any printed material Denmark Dubai USA Singapore www flowcon com 1H95000 04 2016 4 ...
