Operation
Typical Installation Configurations
Important
Batteries should only be filled after
charging.
1
Insert the squeeze bulb filler assembly
into a jug of distilled water. Prime bulb by
squeezing until it is filled with water.
2
Remove the dust cap from the water
supply line and connect it to the squeeze
bulb filler assembly by snapping the quick
couplers together.
4
Immediately disconnect the squeeze bulb
filler assembly from the water supply line
and replace the dust cap.
3
Squeeze the bulb with firm pressure to
begin pumping water into the battery cells.
When the bulb becomes hard, all cells are
full.
5
Any water remaining in the squeeze bulb
filler assembly may be pumped back into
the distilled water jug.
BL-186
11/11
Flow-Rite Controls • 960 74th St., Byron Center, MI 49315 • phone: 616-583-1700 • fax: 616-878-5151 • www.flow-rite.com
Patent Pending
Note: For general winterizing, drain excess water in water supply line by pushing the spring loaded button on the end of the line. To
remove the clear tubing (if necessary), pinch the tubing next to fitting, carefully twist and pull straight off.
The diagrams below show typical battery arrangements and how they might be plumbed with Qwik-Fill. The letters below each diagram
indicate which Qwik-Fill Kits would be required for that configuration. Although the tubing between batteries can be up to a distance of 8’, it
may be more desirable to have separate fill points in the front and rear of the boat.
Fill Point
Battery
Required kit
