FP Air Tools - Florida-Pneumatic Manufacturing Corporation
851 Jupiter Park Lane, Jupiter FL 33458
Troubleshooting
Problem
Possible Cause
Solution
The tool runs slowly or will not
operate.
There is grit or gum in the tool.
Flush the tool with air tool oil or gum solvent.
The tool is out of oil.
Lubricate the tool according to the lubrication
instructions in this manual.
The air pressure is low.
□
Adjust the regulator on the tool to the
maximum setting.
□
Adjust the compressor regulator to the tool’s
maximum setting of 90 psi.
The air hose leaks.
Tighten and seal the hose fittings with pipe thread
tape if leaks are found.
The air pressure drops.
□
Ensure the hose is the proper size. Long
hoses or tools using large volumes of air may
require a hose with an I.D. of ½" or larger
depending on the total length of the hose.
□
Do not use a multiple number of hoses
connected together with a quick connect
fitting. This causes additional pressure drops
and reduces the tool power. Directly connect
the hoses together.
There is a worn rotor blade in the motor.
Replace the rotor blade.
There is a worn ball bearing in the motor.
Remove and inspect the bearing for rust, dirt, and
grit. Replace or clean and grease the bearing with
bearing grease.
There is moisture blowing out
of the tool’s exhaust.
There is water in the tank.
Drain the tank. (See the air compressor manual
for instructions.) Lubricate the tool and run it until
water is not evident. Lubricate the tool again and
run for 1-2 seconds.
Limited Warranty
Florida Pneumatic Manufacturing Corporation warrants its tools to be free from defects in materials and workmanship. Tools thought
to be defective should be returned to the factory, or an authorized service center, transportation charges prepaid, for examination and
consequent repair or replacement. This warranty does not cover damage to tools arising from alteration, abuse, or use for other than their
intended purpose and does not cover any repairs or replacement made by anyone other than Florida Pneumatic Manufacturing Corporation
or its authorized repair stations.
The duration of the Warranty and any other Warranty including, but not limited to, any implied Warranty of merchantability is expressly
limited to two years, beginning from the date of the delivery to the original user. The obligation of Florida Pneumatic Manufacturing
Corporation under any Warranty, express or implied, is limited solely to the repair or replacement at its factory or authorized repair station
of any part which shall prove defective.
