Florence MyPackageConcierge, Installation Manual

Page: 5 / 8

www.florencemailboxes.com MyPackageConcierge® Installation Guide—206562—Rev F Page 5 of 8
C.
After cleaning the integrated trim, carefully run a continuous 3/8” diameter bead of sealant
on the back surface (interior face) of the trim at the head, sill, and both jambs.
• Connect that bead of sealant across any joinery on the integrated trim at all four corners.
• As an option, the sealant can be applied to the wall surface, as opposed to the back of
the integrated trim.
D.
Immediately place MyPackageConcierge® in the wall opening until the integrated trim is flush
against the wall board.
• Ensure the cabinet is square; it may be tilted slightly forward so the bottom slopes toward
the exterior, allowing incidental water to flow outward.
E.
With the door fully open...
1).
Install six (6) #8 x 2” pan-head T20 Torx wood screws ( K64225 ) along both the left- and
right-hand outer frame.
2).
Install two (2) #8 x 2” pan-head T20 Torx wood screws ( K64225 ) along the top frame.
CAUTION: DO NOT drill through, or place fasteners through the bottom of the
MyPackageConcierge®. The bottom has an integrated pan system to
direct any incidental water, that may get into the box, to the outside.
F.
Close the door and turn the knob on the lock counter-clockwise to lock the
MyPackageConcierge®.
NOTE: The #8 x 2” pan-head T20 Torx wood screws should be
tightened to ensure a snug fit.
• Overtightening beyond initial contact with the frame could
hinder functionality.
• If overtightening occurs, simply back out each overtightened
mounting screw.
MOUNTING SCREW
LOCATIONS