FLORABEST FAHE 20-Li B2, Instruction Manual, Page: 12 / 60

FAHE 20-Li B2 GB │ IE │ NI │ CY │ 9 ■
■
Children must not use the appliance
as a plaything. Cleaning and user
maintenance tasks may not be car-
ried out by children unless they are
supervised.
This charger is suitable for
indoor use only.
■
If the supply cord is damaged, it
must be replaced by the manufac-
turer, its service agent or similarly
qualifi ed persons in order to avoid
a hazard.
RESIDUAL RISKS!
■ Even if you operate this power tool properly,
there will still be residual risks. The following
risks can occur in the context of the design
and construction of this power tool:
a) Cuts
b) Hearing damage, if no suitable hearing
protection is worn.
c) Damage to health caused by hand-
arm vibrations if the appliance is used for
extended periods or is not properly used and
maintained.
WARNING!
■ Do not operate the appliance with a dam-
aged cable, power cable or power plug. A
damaged power cable causes danger to life
by electric shock.
Original accessories/auxiliary
equipment
■ Use only the additional equipment and acces-
sories detailed in the operating instructions.
The use of tools and accessories other than
those recommended in the operating instruc-
tions could lead to an increased risk of personal
injury for you.
Before initial use
Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you re-
move the battery pack from or connect the
battery pack to the high-speed charger .
■ Never charge the battery pack when the
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack to the high-speed
charger.
♦ Insert the power plug into the mains power
socket. The red control LED will light up.
♦ The green control LED indicates that the
charging process is complete and the battery
pack is ready for use.
CAUTION!
♦ If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦ If the red and green control LEDs
flash simultaneously, this means that the
battery pack is defective.
♦ Fit the battery pack back onto the appliance.
Attaching/disconnecting the battery
pack to/from the device
Attaching the battery pack:
♦ Allow the battery pack to click onto the rear
handle of the appliance.
Removing the battery pack:
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button
to check the status of the battery. The status/
remaining charge will be shown on the battery
display LED
as follows:
♦ RED/ORANGE/GREEN = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery