11
FORWARD MOVEMENT
The traction of this machine is given through an electronically
controlled motor.
To move the machine, act upon the switch (1), then rotate the levers
drive control placed on the handle bar, in forward you obtain the
forward drive, in reverse the backwards movement is obtained. The
control acts in a progressive way, therefore it is possible to graduate
the speed depending on each requirement rotating the lever
whatever it is necessary. During reverse motion the speed is reduced.
STOP
Releasing the levers drive control, the machine and the brush will
stop.
Moving the machine backwards, make sure that the squeegee is
lifted.
STOP OF THE MACHINE AFTER CLEANING OPERATION
Before executing any type of maintenance:
1.
Close the solution valve lever (7) and check that the indicator of
open solution valve (5) on the instrument board turns off.
2.
Lift the brushes base acting upon the pedal (9).
3.
Lift the squeegee acting upon the lever (8).
4.
Turn the brush motor switch off (3).
5.
Turn the suction motor switch off (4).
6.
Bring the machine to an appropriate place for tanks draining.
The machine is not equipped with a parking brake, therefore do not
leave it on slopes.
DAILY MAINTENANCE
RECOVERY TANK CLEANING
1.
Hold the exhaust hose placed in the front part of the machine.
2.
Take off the exhaust plug acting upon its lever and empty the
recovery tank into appropriate containers (see under
"OVERFLOW DEVICE").
3.
Take off the suction cover (1) after rotating the blocking levers
(2).
4.
Take off the filter and filter protection.
5.
Rinse the tank with a water jet.
SUCTION FILTER CLEANING
1.
Take off suction cover (1) after rotating the blocking levers (2).
2.
Take off the filter and filter protection.
3.
Clean all parts with a water jet especially inside surfaces and
filter bottom.
4.
Carry out carefully the cleaning operations.
5.
Reassemble all parts.
