Floe V-2000, Assembly Instruction

Page: 3 / 4

Fig. 1
Slep
JI
Slide the clamps together over the frame. Insert the 1 /2
11
bolts into the
bolt holes on clamps from the inside of the lift. Slide the spindle through
/
1/2" X 3 1/2" Bolts
the large hole in the clamp, insert the eye bolt through the hole in the end
of the spindle and start nut onto eyebolt. Adjust the 1 /4
11
nylock nut until
the eye of the bolt goes over the 1 /2
11
bolt, followed with the flat washer,
and 1 /2
11
nylock nut as shown in Fig. 1. This will prevent the spindle from
Clamp
spinning in the clamp. Position the clamp assembly so that is 14
11
from the
corner post as shown in Fig. 2. Torque to 35 ft/lbs Note: When installing
nut on the eye bolt make sure that the eye is in alignment with the 1 /2
11
bolt hole.
Slep 1:
Slide a PVC spacer, wheel, then a 2 1 /2
11
stainless steel flat washer over
�
Frame Beam
� 1/4-20 x 3
11
Eye Bolt
the spindle. Insert a spindle clip into one hole in the spindle and pull over
on clip until it snaps into opposite hole in spindle. As shown in Fig. 2.
� .____ 1 /2" Flatwasher
WARN/N(IS:
The flat washer must be installed between the aluminum nut and the eye
1 /2" N lock Nut
bolt to prevent the nut from winding open the eye bolt.
Spindle
y
It is important that you raise the lift cradle at least 2 feet when transporting
1 /4
11
Nylock Nut
the lift in or out of the water. This will prevent the wheels from hitting the
Spacer
Fig. 2
Spindle Clip
side cradle beams, which would prevent the wheels from turning freely. As
shown in Fig. 3.
Fig. 3
Sheet 3 of 4
Important: Raise cradle 24" minimum to prevent
interference with the wheels when transporting.