Fig. 1A
3/8" x 3/4"
Plastic end caps
Fig. 1B
Fig. 1B
3/8" x 2" bolt
Slide clamp tight
against locating plate
Side Frame
Side Frame
Rear Frame
Beam
8"
Fig. 1A
Beam
Front Frame
Adjusting bolt
Rear Frame Beam
Front Frame Beam
against locating plate
Slide clamp tight
Leveling Leg
Step 1
Unscrew 3/8" x 3/4" bolt from leveling legs.
Lay side frames on side. Insert leveling
legs into corner posts making sure the nut
track lines up with lower hole in corner post.
Line up the nut and washer with the hole in
corner post and fasten with 3/8" x 3/4" bolt
that were removed from leveling legs. Leave
leveling leg extended out 8". See Fig. 1 Torque
to 40 ft. lbs.
Clamp front and rear frame beams to side
frames using 3/8" x 2" bolts and nylock nuts.
Torque to 40 ft. lbs. Frame beams to be
located as shown in Fig. 1A and 1B.
Fig. 1
Sheet 4 of 8
Be sure that the drainage holes in the
frame beams are on the bottom at
time of installation.
IMPORTANT NOTE:
