FLO-DYNAMICS BrakeMate, Manual

Page: 14 / 21

2. Select a sequence by touching the “Select” button until the wheel you want to service first is illuminated;
then touch the “Enter/Start” button.
3. Repeat until all wheels have been selected.
4. Touch the “Enter/Start” button again after all wheels have been selected to start the flush.
DISCONNECT:
1. Close all bleeder valves on vehicle.
2. Return to machine and hold “Remove Fluid” button down until vacuum pump begins to run and all four
wheel lights illuminate on control panel.
3. Remove all yellow Tygon lines from bleeder fittings
4. Lower the vehicle.
5. Close ball valve on pressure line and carefully remove from adapter using rag.
6. Remove master cylinder adapter and verify fluid level in reservoir.
ADJUST FLUID LEVEL:
TOP OFF:
1. Connect open end hose to yellow service hose and press “ADD FLUID” button.
2. Slowly open ball valve until fluid reaches the correct level.
3. Replace the master cylinder cover.
REMOVE FLUID:
1. Remove ABS line from holder and attach suction hose.
2. Remove the master cylinder cover and insert suction hose, then press the “REMOVE FLUID” button on
the control panel.
3. Press the “STOP” button when finished removing fluid.
4. Replace the master cylinder cover.
TEST:
1. Start vehicle and check brake pedal to ensure solid feeling.
DRAIN THE WASTE FLUID TANK:
1. Connect the machine’s battery cables to a 12V power source.
2. Connect open-end hose to black service hose and insert into appropriate
disposal container.
3. Open the ball valve.
4. Press “DRAIN WASTE TANK” button on the control panel.
WARNING!
Brake fluid is highly corrosive, and will damage surfaces if not cleaned up promptly. Always check for
brake fluid under the machine before storing, especially under the back of the machine where new fluid is
filled. Any spills should be cleaned up immediately.
14