FLIR Lepton 1.5, Engineering Data Sheet

Page: 42 / 84

FLIR LEPTON® Engineering Datasheet
The information contained herein does not contain technology as defined by the EAR, 15 CFR 772, is publicly available,
and therefore, not subject to EAR. NSR (6/14/2018).
Information on this page is subject to change without notice.
Lepton Engineering Datasheet, Document Number: 500-0659-00-09 Rev: 203
42
Parameter
Power-
On
Default
Section in this document
Telemetry
Line Location
RAD Spotmeter Value N/A
Radiometry Modes , page 29 C50-53
RAD Flux Linear
Parameters (8192, 29515, 8192,
29515, 8192, 29515,
0, 29515) Radiometry Modes , page 29 B19-26
4.1.1 User Defaults Feature
The user defaults feature allows the user to write desired operational defaults, such as those described in the CCI
above, to OTP such that an initialization sequence is not necessary at start-
up. The “OEM User Defaults”
command is described in the Software IDD. The list of parameters that are included in the user defaults memory
location are described in
Table 7
.
Table 7 - Parameters stored in the User Defaults OTP Memory Location
Parameter
Power-On
Default
Section in this document
AGC Mode Disabled AGC Modes, page 34
AGC ROI
12
(startCol, startRow, endCol, endRow)
(0,0,79,59) or
(0,0,159,119) AGC Modes, page 34
AGC Dampening Factor 64 AGC Modes, page 34
AGC Clip Limit High
12
4800, 19200 AGC Modes, page 34
AGC Clip Limit Low 512 AGC Modes, page 34
SYS Telemetry Mode Disabled Telemetry Modes , page 23
SYS Telemetry Location Footer Telemetry Modes , page 23
SYS Number of Frames to
Average
8 FFC States , page 18
12
First set of coordinates refer to Lepton 1.5, 1.6, 2.0 and 2.5. The second set refers to Lepton 3.0 and 3.5.