FLIR FLIR TG167, User Manual

Page: 25 / 68

Operation 8
3. Move the camera until only the object of interest is between the laser pointer spots.
4. The measured temperature is displayed on the camera screen.
Note If the temperature exceeds the measurement temperature range of the camera,
OL is displayed on the screen.
8.4 Saving an image
8.4.1 General
To save images, a compatible Micro SD card must be inserted in the Micro SD card slot at
the top of the camera (under the protective flap). When the camera is connected to a PC
via a USB cable, the memory card functions as an external storage drive.
The images are saved in bitmap (bmp) format, with the temperature reading and the cur-
rent emissivity setting displayed.
8.4.2 Naming convention
The naming convention for images is FLIRxxxxx.bmp , where xxxxx is a unique counter.
8.4.3 Procedure
Follow this procedure:
1. Aim the camera toward a point of interest.
2. Pull and hold the trigger. This activates the two laser pointers.
3. Release the trigger to capture the image. This freezes the image for 5 seconds.
4. Within 5 seconds, do one of the following:
• To save the image, push the button.
• To discard the image, push the button.
Note If no button is pushed within 5 seconds, the image is automatically discarded.
5. If the image is stored successfully on the memory card, a large check mark is
displayed.
If the camera fails to save the image, a large failure icon is displayed. A failure may
indicate a full, faulty, or incorrectly inserted memory card.
#T559974; r.33562/33594; en-US
15