Elara FR-345-EST QIG Rev 110
December 2020
This document does not contain any export-controlled information.
Important
After powering up the camera, wait 30 minutes before
commencing screening. The camera's thermal sensor needs to
stabilize. In System Settings, click
Firmware & Info
, and make
sure the Temperature is stable.
For information about using the camera's web page to perform additional
configuration steps, see the camera's installation and user guide.
6 Attach the Camera to a Supported VMS
After you have mounted the camera and discovered or defined its IP address, you
can use VMS Discovery/Attach procedures to attach the camera to a supported
VMS.
7 Camera Dimensions
The Elara FR-345-EST camera’s dimensions are:
Side View
Front View
8 Register the Product
Register your Product with FLIR at
center/warranty/security/flir-security-product-warranties/
.
9 Contact Information
FLIR Systems, Inc.
6769 Hollister Avenue
Goleta, CA 93117
USA
Support:
Corporate Headquarters
27700 SW Parkway Ave.
Wilsonville, OR 97070
USA
