Dimensions
Camera Specifications
Installing the Camera
Setting up the Camera
Camera Base
1. Rotate the camera base counterclockwise to
separate it from the ball camera and dome
cover.
2. Feed the BNC / power cable through the camera
base.
3. Connect the video and power cable as shown in
the next section ‘Setting up the Camera’.
4. Mark the position of the 4 holes in the camera
base. Drill holes where marked.
5.
OPTIONAL:
Insert drywall anchors as needed.
6. Mount the camera base to the wall or ceiling
using the included screws.
7. Position the dome cover over the camera and
screw it clockwise halfway onto the camera
base.
8. Move the ball camera to the desired position.
While holding the ball camera firmly in place,
screw the dome cover the rest of the way
to secure it to the camera base. Holding the
camera prevents it from moving while installing
the dome cover.
95mm / 3.8”
70mm / 2.8”
1. Connect the BNC connector of the camera to
the video cable.
2. DC Power—
Power Adapter
: Connect a
12V DC Power Adapter (not included) to the
camera. Plug the Power Adapter into a local
power outlet.
• DC Power—
Power Pigtail
(not included):
Connect a Power Pigtail to the camera.
Connect the terminating wires of the cable
directly to the DC power source.
NOTE:
For pigtail connection with 12V DC, make sure
to check polarity specifications on the power adapter.
Image Sensor
1/3” 960H Image Sensor
Video Format
NTSC
Effective Pixels
H: 960 V: 480
Horizontal Resolution
700 TVL
Scan System
2:1 Interlace
Sync System
Internal
S / N Ratio
48dB (AGC Off)
Iris
AES
AES Shutter Speed
1/60 ~ 1/25,000 sec.
Min. Illumination
0.3 Lux without IR LED
0 Lux with IR LED
Video Output
Composite 1.0Vpp @ 75ohm
Lens Focal Length / Type
3.6mm F2.0 / Fixed
FOV (Diagonal)
80°
Termination
BNC Type
IR Range / Qty.
65ft / 20m; 20 IR LED’s
Power Requirement
12V DC ±10%
Power Consumption
12V: 270mA Max with IR LED
Operating Temp. Range
–22° ~ 122°F / –30° ~ 50°C
Environmental Rating
IP66
Dimensions (LxH)
2.8” x 3.8”
70mm x 95mm
Weight (including stand)
0.7lbs / 0.3kg
ATTENTION
- Test the camera prior to selecting a permanent
mounting location by temporarily connecting the camera(s) and
cables to the DVR.
ATTENTION
- This camera includes an Auto Mechanical IR Cut Filter.
When the camera changes between Day/Night viewing modes, an
audible clicking noise may be heard from the camera. This clicking is
normal, and indicates that the camera filter is working.
