16.1
M12 connector pin configuration
This section specifies the pin configuration for the M12 connector at the rear of the
camera.
Figure 16.1
Pin assignment M12 male connector: 12 positions, male side view.
Table 16.1
Mapping table, pin to signal
Pin
Signal
Explanation
1
RET_GB
Camera PWR –
2
PWR_GB
Camera PWR +
3
SYNC_OUT
LVC Buffer @ 3.3 V, ”0” = 24 MA
max, “1” = –24 mA max.
4
SYNC_OUT_GND
= RET_GB = Camera PWR –
5
SYNC_IN
LVC Buffer @ 3.3 V, “0” < 0.8 V,
“1” > 2.0 V
6
SYNC_IN_GND
= RET_GB = Camera PWR –
7
GPO+
1 × opto-isolated, 2–40 VDC,
max. 185 mA
8
GPO–
= GP Input return
9
GPIO_PWR
GP Output PWR. 2–40 VDC,
max. 200 mA
10
GPIO_GND
GP Ouput PWR return
11
GPI+
1 × opto-isolated, “0” < 2, “1” =
2–40 VDC
12
GPI-
GP Input return
Cables for the M12 connector are available from FLIR Systems. See the part numbers
below.
• T127605, Cable M12 pigtail.
• T127606, Cable M12 sync.
#T559770; r. AL/81723/81723; en-US
78