8.2.3.1.5
Narrow FoV/Wide FoV
Changes the current field-of-view in use from
Wide FoV
(normal) to
Narrow FoV
(zoomed), or back.
8.2.3.1.6
Man. level/span
When selected, level & span values are locked, and a dialog box is shown at the
bottom left of the display. The left/right arrow buttons are used to select either the
level or span for adjustment, while the up/down arrow buttons adjusts the setting.
Pressing ENTER accepts these setting for the image and removes the control bar.
Pressing the C button will reset the level & span to the previous values.
Man. Lev-
el/span
can be selected again to continue the adjustments.
NOTE: The system will remain in manual level/span mode until
Auto level/span
is selected.
8.2.3.1.7
Auto level/span
When selected, the system will automatically select an image enhancement method
for best overall image contrast. The method selected depends on the settings in the
Setup – Image dialog
box.
8.2.3.1.8
Power off/Power off
This function switches off the power to the detector module. A test image will be dis-
played.
8.2.3.1.9
Slave mode on/Slave mode off
When
Slave mode on
is selected, and the operator switches to TV mode, the same
field of view as in IR mode will be used and the camera will carry out an autofocus
sequence.
8.2.3.2
When TV is selected
10597103;a1
Figure 8.2
Image
menu when TV is selected
8.2.3.2.1
Declutter
This is the same function as when IR is selected.
18
Publ. No. 1 557 544 Rev. a121 – ENGLISH (EN) – October 6, 2005
8.2 – On-screen menus
