Install VESA mount
• Remove the stand from your
monitor and use the screws
provided with your display to
install the female part of the
mount.
• Bring the monitor to the male
half of the mounting system
and let the monitor snug into
place. Gravity does the work.
• A spring loaded keeper pin
with a red release knob will
engage.
• To remove the display, push
back the keeper and lift the
display up out of the couple.
The male half of the VESA mount is
attached to the flipIT lid with three
Euroscrews. Additional mounting
locations, at half-inch intervals, are
provided to fine-tune the balance
of the opening performance. If the
monitor is mounted too high, it will
not pass through the cutout.
If it is mounted too low, the opening
might be too fast (like jumping off a
teeter totter).
The VESA mount
provides screen
angle adjustment.
• Adjust the screen angle by grasping
the lid and display top and squeeze
the top to reduce the angle.
• Increase the angle by holding the
lid with one hand and the top of the
display with the other, then bring the
display toward you.
12
technical support 800-770-7042
www.smartdesks.com
