I N S T A L L A T I O N M A N U A L
flipIT
®
monitor mount system
US Patent No. 7,509,912
1. Use included templates for cutting table top
and pilot holes; or
2. Start on page 8 to install flipIT® into a factory-cut
table top with pilot holes.
This manual is used for all flipIT®
monitor mount systems.
The difference in cut-out
width dimension has no impact
on the installation procedure.
The appropriate template is
included with your flipIT Kit
for 19 or 23 configuration.
ATTENTION:
The weight of the monitor counterbalances the force of the
pneumatic cylinder (gas spring).
It is advised to install the gas spring just before installing
the monitor. If the gas spring is installed without a monitor,
take care to control the lid by hand. The lid will open too
fast if the monitor is not installed.
Models FIK-19 and FIK-23 include a keyboard
tray which assists in opening the flipIT® lid.
Models FIH-19 and FIH-23 have no keyboard
tray, but include a PULL handle for opening.
Technical Support:
www.smartdesks.com
800-770-7042
Procedure for
these models:
•
FIK-19
•
FIH-19
•
FIK-23
•
FIH-23
©2015 CBT Supply, Inc. dba SMARTdesks®. All rights reserved. SMARTdesks and flipIT® are registered trademarks of CBT Supply, Inc.
REV 08252015
