FT-111(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019
Page
30
of
146
Powerlink
Figure 4.25
- PLC Connection
Powerlink Connector pin configuration (RJ45)
Pin
Signal
DIR
Description
1
TX+
Out
Differential Ethernet transmit data +
2
TX−
Out
Differential Ethernet
transmit data −
3
RX+
In
Differential Ethernet receive data +
6
RX−
In
Differential Ethernet receive data −
4
Not used
Terminated
5
Not used
Terminated
7
Not used
Terminated
8
Not used
Terminated
Shield
Chassis ground
The HUB connection cabling will be a direct connection as shown below:
Figure 4.26
- HUB connection
CC-Link IE
Figure 4.27
- PLC Connection
CC-Link IE Field Connector pin configuration
Pin
Signal
Description
1
TP1+
Transmit/Receive 1 positive
2
TP1-
Transmit/Receive 1 negative
3
TP2+
Transmit/Receive 2 positive
6
TP3+
Transmit/Receive 3 positive
4
TP3-
Transmit/Receive 3 negative
5
TP2-
Transmit/Receive 2 negative
7
TP4+
Transmit/Receive 4 positive
8
TP4-
Transmit/Receive 4 negative
Housing
Shield
Connected to FE through a 1 nF capacitor and a 1
Mohm resistor. Note that the connector shields are
separated to prevent ground currents.
