Flightline SPITFIRE MK.IXC, User Manual, Page: 8 / 15

P NP Assembly Instructions
Scale parts Installation
1.Glue the Radiators A and B to the main wing surfaces,
as shown.
� �
Cannon barrels
3.lnsert the cannon barrels to the main
wing. Glue is not required. This part can
be removed for transport.
-
Screw
--------­
(PWM4 x8 mm)
EN
Stepf)
4.Use clear canopy glue to attach the scale rearview mirror to
the clear canopy. Do not use CA glue. CA glue may damage
the clear canopy. Finally, insert the antenna into the top of the
fuselage. Glue is not required. This part can be removed for
transport.
h
Rea�iew Micco,
r--=
�
Antenna
Introduction to t
he Control board
Control board Instruction
Using the diagram as a guide, insert the landing gear,
LED lights and flaps into the designated input plug.
Then plug the Flap, L-G and Ail output plugs into the
receiver. Rudder and elevator servos will plug directly
into the receiver.
Control board functions:
1. Replaces Y-cables and other connection cables,
allowing for a cleaner wiring job and better quality
connections.
2. The board is an all-in-one control surface/LED
light control board.
Flap servo
•
• •
Aileron servo
• • •
Landing-GearO
• • •
Landing-Gear@
....
• •
Landing-Gear@>
• • •
Strobe-Light
•
•
Strobe-Light
....
•
• •
• •
•
• •
RECEIVER
mi&m
ll'v' �-, d'v'l::l
FIAP FIAP
AIL
AIL
L-G
G-D
L-G
G-D
L-G
G-D
Light Light
Light Light
• •
• •
• •
• •
• •
• •
•
Flap servo
•
Aileron servo
•
Landin -Gear Door
0
Landin -Gear Door @
Landin -Gear Door 8
Wing-Light
Landing -Light
!iPITFIRE MK.IXc
lten No.: FLW303
2.Use 1xPWM4x8mm screw to attach the air intake.
Note: After completing the above steps, depending on the model of your control board, insert the
aileron, flap and landing gear cables to the control board.