Installation / Operation Manual
anemoi
02.04.2022 | V1.02
-25-
After choosing a duration (Figure 6-8) and confirming (Figure 6-9), AHRS will be locked for the chosen
amount of time. Note that GPS signal is required to lock the AHRS, as time and date information is
transferred via NMEA. If no GPS signal is available, the system will not be locked, and an error message
will be displayed.
After the system has been locked, instead of the AHRS main page (Figure 6-3), a locked page (Figure
6-10) will now be displayed. The date indicated on top of the page is the first day on which the AHRS
will be available again.
Figure 6-8: Disable AHRS page 1
Figure 6-9: Disable AHRS page 2
Figure 6-10: AHRS locked page
Align DOF
By default, direction A points in the DOF. If the sensor unit is installed in any of the three other
directions (e. g. B/C/D) this needs to be set in the menu.
To set the direction of flight in which the sensor unit is mounted, open the “Align DOF” option and
select the correct orientation, then hold the button to confirm. The Align DOF page is shown in Figure
6-11.
Figure 6-11: Align DOF page
Exit
Holding the push button, exits the setup operation menu and restarts the
anemoi
with the startup
screen, as can be seen in Figure 6-1. After that the wind page shows up.
Hold to
confirm
Disable for 21 days
Press to select AHRS
disable duration
Wait to cancel
Do you want to disable
AHRS for 21 days?
Press to confirm
Locked until 21-06-2022
change DOF
Press to
Hold to
save + exit
B
