●
Make sure to apply Vaseline to
the rudder hinges to prevent the
epoxy from getting in to the joint.
●
Make sure to allow room for
epoxy to penetrate the hinges.
Carefully slide the rudder onto
each hinge and against the trailing
edge of the fin.Wipe away excess
epoxy with alcohol wetted wipes.
●
Ensure there is no gap
between fin and rudder.
Install the rudder servo in the
fuselage that prepared by factory.
Feed the rudder cable through the
cable exit tube in the tail of the
fuse toward the front of the fuse.
Repeat on other side.
Adjust rudder pull-pull cables
to desied tension by screwing in
or out on the threaded couplers
and or ball links.Make all adjust-
ments with the rudder servos still
rudder still taped in the neutral
position.
RUDDER AND TAIL WHEEL
Push
rods
Rudder
servo arm
P.4
