Fliegl ULW, Operating Instructions Manual

Page: 37 / 84

ULW transfer trailer Start-up
Fliegl Agrartechnik GmbH, 84453 Mühldorf am Inn, Germany
35 of 85
5. Start-up
5.1 First-time start-up
- Without a correct start-up in accordance with these operating
instructions, the operational safety of the machine is not
guaranteed. This can lead to accidents resulting in serious injury or
death.
- All setting and adjusting tasks must be performed for first-time
start-up.
- Before starting work, the operator must familiarise himself with all
actuating devices and their function.
It is too late to do so once work has started.
- Before every start-up, check the trailer for operational and
transport safety.
- Before start-up, instruct persons to leave the danger area, e.g.
around hydraulic equipment, drives.
- There is a risk of injury at crushing and shearing points in the area
of the: rear panel, moving panel unit and drawbar.
- Before starting up the vehicle, ensure that there are no persons or
obstructions behind the trailer.
- If the roadway behind the trailer is not or only partially visible,
reversing must be monitored by a signaller.
- Observe the safety instructions that are affixed to the trailer. An
explanation of the individual warning symbols is provided on page
24 of these operating instructions.
- Also comply with the instructions in the relevant sections and in
the appendix of these operating instructions.
5.2 Check before start-up
The points below will facilitate trailer start-up.
For more detailed information, refer to the relevant sections in the operating instructions.
Check to ensure that all safety devices (covers, panels etc.) are in proper condition and are attached to
the trailer in protective position.
- Check the cargo space for loose parts lying inside.
- Check the condition of the screw conveyors.
- Lubricate the trailer according to the lubrication schedule.
- Check the hydraulic lines for leaks.
- Connect all connecting lines (e.g. hydraulics, compressed air etc.) correctly and secure them.
- Check the tyres to ensure the air pressure is correct.
- Check the tightness of the wheel nuts.
5.3 Returning to service
After an extended storage period, the same steps as for first time start-up must be completed.
See section 5.1.